The Bison Blog

Automatic sawing with programmable mitre cutting

For many years fabricators have proved the benefit of automatic saws to produce small parts from long bar stock. Setting an automatic bandsaw to cut 100 off 25mm long components is a massive productivity boost when compared to an operator producing these manually. Many saws however are set up for 90 degree - or straight cutting - only. So what are the options if mitred components are required?

Read More

Bump bending a radius using a press brake

Are you using bending rolls to form a radius in sheet or plate material? This is by far the easiest option if you are rolling a full cylinder or a partial segment, but what about if you need a curve between two flat parts with accurate dimensions? This can be tricky, but there is another option……

Read More

Morgan Rushworth 4-Roll NC Plate Bending Rolls

The Morgan Rushworth 4 Roll Hydraulic Plate Bending Rolls are a proven success story with many successful installations around the world. The addition of an NC control allows a skilled operator to program a job ready for production by any trained personnel.

Read More

Save Space With a Return to Sender Guillotine

When selecting a metal cutting guillotine one of the key considerations is the space that they take up in a workshop. As well as needing room at the front of the machine for the operator and the metal sheet, there is normally a need to access the rear of the machine to collect parts or remove scrap.

Read More
  • Follow Our Social Channels